In this article, we cover how to leverage the Verisk + HOVER integration when you're starting in X1, capturing a job through the HOVER app and then finishing the estimate in X1 once the measurements are ready.

NOTE: All Xactimate screenshots reference the older version of Xactimate, X1. Some differences will exist if you're using Xactimate Online (XOR).

NOTE: The workflow outlined below shows the minimum amount of information required for the integration to function. You may need to enter more information for your specific process than what is covered here.


Request Data

  • On the Local Projects screen in Xactimate, click on your project so it’s highlighted in blue

  • Click on the house icon which is the 5th icon from the top, on the right side of the screen

  • A pop-up window titled “Request Data” will appear.

    • Select Property Data (even if you are using HOVER for just roof measurements)

    • Click NEXT

  • Select one of the HOVER options from the provider drop-down list:

    • Use HOVER Roof for roof only measurements

    • Use HOVER Roof and Walls for complete roof and elevation measurements

    • Validate that the data entered in the "Request data" window is correct

    • Click OK

  • You will immediately see a notification that says: "Succeeded"


Capturing a Property in HOVER

  • When onsite at the loss location, open up the HOVER app

  • The Xactimate project will automatically appear as a HOVER “Draft” job - Tap to open the job

  • All of the claim details auto-populate from Xactimate

  • Tap Take Photos

  • Capture the HOVER photos as normal - walk around the property taking a photo of each face and corner

  • Add damage photos, if desired

  • Tap Continue when done taking photos and then Tap Finish so HOVER can start processing the job:

  • HOVER will notify you when the job is complete


Importing HOVER Data into Xactimate

  • You'll be notified in Xactimate when the measurements are ready

  • Back on the Local Projects page, click the project so that it's highlighted in blue

  • Click on the pencil icon which is the 6th icon from the top, on the right side of the screen

  • On the new window, you’ll see the estimator tool on the left side of the screen. Under “Estimate” choose the “Sketch” tab

  • Click the icon in the top left corner of the sketch window

    • You'll see the HOVER measurement data is available to pull in

    • Click Import

  • The HOVER measurements and 2D/3D sketch will import into your estimate

  • From the estimator tool, you can click on the “Photos” tab to see all the imported photos for each structure in one place (including damage and annotated photos, if applicable).


Additional Resource

Frequently Asked Questions (FAQs)

Did this answer your question?